Motion Control Damper Adjustment; Motion Control Neutral Lock Pivot Adjustment; Motion Control Handle Adjustment - Exmark Lazer LZE Operator's Manual

Motion Control Damper
Adjustment
The top damper mounting bolt can be adjusted to
obtain a more desired motion control lever resistance.
See Figure 58 for mounting options.
Figure 58
RH Motion Control Shown
1. Torque nyloc nut to 200 in-lb (16.7 ft-lb). Bolt must
protrude past end of nyloc nut after torque. A T-40 Torx
bit will be necessary to hold the stud from turning.
2. Most resistance (firmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
Motion Control Neutral Lock
Pivot Adjustment
The flanged nut can be adjusted to obtain a more
desired motion control lever resistance (Figure 59).
Figure 59
1. Flanged nut
g008620
g008621
2. Jam nut
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired
feel.
For more resistance, tighten the flanged nut.
For less resistance, loosen the flanged nut
3. Tighten jam nut.
Motion Control Handle
Adjustment
Adjusting the height:
The motion control levers can be adjusted higher or
lower for maximum operator comfort.
1. Remove the two bolts holding the control lever to
the control arm shaft (Figure 60).
1. Bolts
2. Control lever
3. Control arm shaft
2. Move the control lever to the next set of holes.
Secure the lever with the two bolts.
3. Repeat the adjustment for the opposite control
lever.
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever
to the control arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever fore or aft Figure 60. Tighten both
bolts to secure the control in the new position.
3. Repeat the adjustment for the opposite control
lever.
73
Maintenance
Figure 60
4. Nuts
5. Slotted holes
g008631