Exmark Lazer LZE Operator's Manual page 32

Operation
The LCD indicator will appear when the PTO
switch is disengaged (see Figure 11 and Figure 12).
Refer to the Hour Meter User's Guide for more
information.
PTO Engagement Switch (LZS and
LZX EFI Models)
Located below the RED Equipped LDU on the RH
console (see Figure 8).
Switch must be "ON" (pulled up) to engage the
blades. Switch is "OFF" (pushed down) to disengage
the blades.
The LCD indicator will appear on the information
screen of the RED Equipped LDU when the PTO
switch is disengaged.
Note: The RED Equipped Models have a clutch
saver, which allows the throttle to automatically
reduce engine RPM when the PTO switch is
disengaged. Engaging and disengaging the PTO
switch, changes the engine throttle between mow and
transport mode.
Note: The starter will crank with the PTO switch in
the "ON" (pulled up) position; however, the system
will disengage the PTO and a PTO reset error will
occur. Engaging the PTO will require the operator to
reset the PTO switch by turning it "OFF" (pushed
down) and then turning it "ON".
Important: On Wing Deck Model: The wings
must be unfolded before the PTO can be
engaged.
Low Voltage Indicator
(For all LZE Models and all LZS/LZX
Kawasaki Models Except RED
Equipped Models)
Located on the right console in the message display
(seeFigure 6 and Figure 11).
A low voltage condition (less than 12.3 volts) exists
when the LCD indicator appears on the message
display while the engine is running.
If the ignition key is turned to the "ON" position for
a few seconds before cranking the engine, the battery
voltage will display in the area where the hours are
normally displayed.
Note: The indicator normally appears when the
engine is off and the key switch is turned to the
"ON" position.
Low Voltage Error
(For LZS/LZX EFI Models)
Located on the right console in the message display.
Refer to the Hour Meter User's Guide for more
information.
Deck Lift Pedal
Located at the right front corner of the floor pan.
Push the pedal forward with your foot to raise the
cutting deck. Allow the pedal to move rearward to
lower the cutting deck to the cut height that has been
set.
Deck Lift Switch–Wing Deck Models
Only
Located on the RH console (see Figure 8).
Push the top of button to raise the center deck and
fold up the outer wings.
Push the bottom of button to lower the center deck
and outer wings.
Transport Lock
Located on the height of cut adjustment plates to the
right of the parking brake.
Position in the transport latching position to
automatically latch the cutting deck when raised to
the transport position (see item 1 in Figure 14).
In the non-latching position, the deck will
automatically return to the cutting height when the
pedal is lowered (see item 3 in Figure 14).
32