Motion Control Full Forward Tracking Adjustment; Caster Pivot And Gauge Wheel Pivot Bearings Pre-Load Adjustment - Exmark Lazer LZE Operator's Manual

Maintenance
Motion Control Full Forward
Tracking Adjustment
If the machine travels or pulls to one side when the
motion control levers are in the full forward position,
adjust the cover plates.
1. Loosen the screws on a cover plate (see Figure 61).
2. Slide the cover plate backward or forward to
adjust the travel of the lever and tighten the
screws.
3. Drive the machine and check the full forward
tracking.
4. Repeat steps 1 through 3 until desired tracking
is obtained.
RH Motion Control Shown
1. Screw
2. Cover plate
Caster Pivot and Gauge
Wheel Pivot Bearings
Pre-Load Adjustment
Remove dust cap from caster and tighten nyloc nut
until washers are flat and back off 1/4 of a turn
to properly set the pre-load on the bearings. If
disassembled, make sure the spring disc washers are
reinstalled as shown in Figure 62.
Figure 61
3. Motion control lever
All Models Except Wing Deck
1. Spring disc washers
g010015
1. Spring disc washers
74
Figure 62
Figure 63
Wing Deck Models
g006131
g228558