Motion Control Damper Adjustment; Motion Control Neutral Lock Pivot Adjustment - Exmark LAZER Z X Series Operator's Manual

Maintenance
Figure 47
1. Double nuts
8. Shut off unit. Remove jumper wire from wire
harness and plug connector into seat switch.
9. Remove the jack stands.
10. Raise the deck and re-install the height of cut pin.
11. Check that the machine does not creep in neutral
with the park brakes disengaged.
Motion Control Damper
Adjustment
The top damper mounting bolt can be adjusted to
obtain a more desired motion control lever resistance.
See Figure 48 for mounting options.
RH Motion Control Shown
1. Torque nyloc nut to 200 in-lb (16.7 ft-lb). Bolt must
protrude past end of nyloc nut after torque. A T-40 Torx
bit will be necessary to hold the stud from turning.
2. Most resistance (firmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
Motion Control Neutral Lock
Pivot Adjustment
The flanged nut can be adjusted to obtain a more
desired motion control lever resistance (Figure 49).
1. Flanged nut
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired
feel.
For more resistance, tighten the flanged nut.
For less resistance, loosen the flanged nut
3. Tighten jam nut.
56
Figure 48
Figure 49
2. Jam nut