Door Gasket; Vent Parts (On Some Models); Detergent Dispenser - Haier GE GDF510P M4 Series Service Manual

Door Gasket

1. Remove the door.
2. Place the door on a protected surface to
prevent damage.
3. On plastic inner door models, slide the gasket
either direction to remove. The door does not
need to be separated on plastic inner doors.
End View
4. On stainless steel inner door (hybrid) models,
the inner door panel has the door gasket
riveted to the panel. The inner door panel
must be replaced to replace the door gasket.

Vent Parts (on some models)

Front Control Models
Console Insulation
Gasket
Vent
Gasket
Conduit
Top Control Models
Insulation
Gasket
Handle Bracket
and Grill
Vent
Conduit
Insulation
Front Panel
Gasket

Detergent Dispenser

The detergent dispenser is solenoid operated,
using 13.5 VDC to activate the solenoid.
Some models have a rinse agent dispenser.
The dispenser holds 3.5 oz. (100 ml.) of rinse
agent. Under normal conditions, this will last
approximately one month.
The module receives 13.5 VDC for .5 seconds to
activate the detergent cup. To activate the rinse
aid, the module receives 13.5 VDC for a period of
15 seconds.
To Diagnose the Detergent Module
1. Remove power to dishwasher.
2. Remove toe kick panel.
3. Disconnect door harness.
4. Remove and separate the door.
5. The inner panel may be set into the
dishwasher and latched in the closed position.
6. Reapply power.
7. Place the dishwasher into Service Mode (see
Service Mode under the Electronic Controls
section in this service guide), then activate
the detergent test to check for 13.5 VDC to the
detergent module. Service Mode will provide a
15 second activation time.
Detergent Dispenser Removal
1. Remove power to the dishwasher.
2. Remove and separate the door.
– 37 –