Outer Door Panel; Inner Door Panel - Haier GE GDF510P M4 Series Service Manual

Outer Door Panel

Outer Door Panel Components
Bar Handle
Handle Brackets
Handle Screws
Vent Insulation
Vent Gasket
Vent Conduit
Badge
Cross
Brace
Screws
Pad
Cross Brace
(SS Inner Door Models)
(SS Inner
Door Models)
Bar Handle
The bar handle is attached to the outer door
panel. The handle is an assembly with end caps
pre-attached.
Bar Handle Removal
1. Remove and separate the door.
2. Remove the vent conduit (two 1/4-inch hex-
head screws).
3. Remove two 3/8-inch hex-head, 1/4 -28
thread size screws holding the handle.
Gasket
Insulation

Inner Door Panel

Stainless Steel (SS) Door Attach Strips
Attachment strips are used on stainless steel
(SS) door attach strips models only; plastic inner
doors have this feature molded into them. Strips
also have a boss on each side for the screw to
secure the inner and outer door panels.
Top
Console
Side Attach
Strip
Attachment Strips Removal
1. Remove and separate the inner and outer
door panels.
2. Remove the front control console or top
control panel.
3. Remove the two T15 Torx-head screws on the
side attach strips.
4. Slide the strip inward to remove.
5. To remove the top attach strip, slide the strip
down after the top console and side attach
strips have been removed.
– 36 –
Side Attach Strip
Screws
(T15 Torx)
Top Attach Strip
Side Attach Strips