Door - Haier GE GDF510P M4 Series Service Manual

Door

The door receives DC voltage only and has a
screwless appearance. The door contains a UI
(User Interface) board with all tactile switches
on the board. Some models have a 7-segment
display (SSD); others have LED indicator lights.
The door also houses the detergent module,
bottom door seal and a passive venting system
(see the Dry System section in this service
guide).
Door Removal
1. Remove power to the dishwasher.
2. Remove the toe kick.
3. Disconnect the door wire harness at the
bottom of the main control cover.
4. Release the wire clip holding the harness to
the tub.
5. Remove two 1/4-inch hex-head screws at the
bottom of the door.
1/4-in. hex-head screws
6. Locate the hinge pin locking point hole in tabs
of left and right side of each offset leg (left
side shown below).
Point
Hole
Left side
hinge arm
Left side offset leg
7. Insert a 5/32 Allen wrench (or similar size
tool) through this hole, gradually open door
to 30 degrees and continue to insert the Allen
wrench through both the offset leg and hinge
arm, until locking of the hinge has completed.
TIP: Using a "tool" with a tight fit will produce the
best results and easier door installation.
– 28 –
(Continued next page)