Ricoh A-P3 Service Manual page 29

3000-SHEET FINISHER INSTALLATION (A697)
[G]
[D]
[F]
A697I550.WMF
7. If the customer requires the punch unit, install it now, before attaching the
finisher to the machine. See 'Punch Unit Installation'.
8. Open the front door of the finisher, and remove the screw [A] that secures the
locking lever [B]. Then pull the locking lever.
9. Align the finisher on the joint brackets, and lock it in place by pushing the
locking lever.
NOTE: 1) Before securing the locking lever, make sure that the top edges of
the finisher and the copier are parallel from front to rear as shown
[C].
2) Secure the locking lever (! x 1) and close the front door.
10. Install the shift tray guide [D] on the shift tray. If the customer does not wish to
install it on the shift tray, store it at the location [E].
NOTE: The shift tray guide helps to properly stack exiting paper. However, it
reduces the capacity of the shift tray by 50, from 3,000 to 2,950.
11. Install the shift tray [F] (! x 4).
12. Connect the finisher cable [G] to the main machine.
13. Turn on the main power switch and check the finisher operation.
[C]
[B]
[A]
[E]
1-18
6 November, 2001
A697I534.WMF