Ricoh A-P3 Service Manual page 152

PRINTER ENGINE SERVICE MODE
SP5 Mode Number
5907* 01 Plug & Play
5915 01 Mechanical Counter
Detection
5930 Meter Charge
5958 Feed Clutch Timing
5970 Debug Serial Output
5990 SMC Printouts
1 All (Data List)
2 SP (Mode Data List)
4 Provisionally
5 Diagnosis Report
7 NIB Summary
Function and [Setting]
Sets the brand name and the production name
for Windows Plug & Play. This information is
stored in NVRAM. If the NVRAM is defective or
has been replaced, these names should be
registered again.
To set the plug and play model name, enter the
model number, and then press #(Enter).
Checks whether the mechanical counter inside
the inner cover is connected or not.
Display:
0: Not detected
1: Detected
2: Unknown
This is a total count system for the PCU, fusing
unit, etc. When this setting is set, the PCU
replace time status is not issued from the
engine. However, the internal copy count
continues to function.
Adjusts the clutch timing to optimize the intervals
between fed sheets to reduce jams in the feed
unit. DFU
[35 ~ 57.5 / 42.5 / 2.5mm step]
DFU
DFU
Prints all of the system parameter lists for the
item selected.
5-24
6 November, 2001