Table of Contents
Advertisement
6 November, 2001
SP5
Mode Number
5828*
47
Network Job Analysis
Timeout Setting (Centronics)
48
Network Job Timeout Setting
(Centronics)
49
Network Noise Cancel
Setting (Centronics)
50
Network 1284 Compatibility
Setting (Centronics)
51
Network Data Transfer
Speed Setting (Centronics)
52
Network ECP Setting
(Centronics)
53
Network Transmission
Speed Setting
66
Start Time Job Spool Clear
5839
07
IEEE1394
08
BCR Mode
09
1394a Check for IRM
10
Unique ID Enumeration
11
Force Logout
12
Exclusive Login
13
Maximum Initiator Number
for Login
PRINTER ENGINE SERVICE MODE
Function and [Setting]
Sets the Centronics job analysis timeout for the
network.
[0 ~ 4,200 s / 3 s / 1 sec. step]
Sets the Centronics job timeout for the network.
[0 ~ 4,200 s / 0 s / 1 sec. step]
Sets the noise cancel level for the network.
[4 ~ 7 / 4 / 1 clock per step]
Switches Centronics IEEE1284 compatibility
on/off for the network.
0: Disabled, 1: Enabled
Selecting "0" disables bi-directional data
transmission.
Sets the Centronics transfer speed for the
network.
0: Slow, 1: Fast
If you select "0" there will be a 120 µ s delay from
the STP signal to the data transfer. (With 1:
FAST there is no delay.)
Switches the ECP setting for Centronics off/on.
0: Disabled, 1: Enabled
With "1" selected, SP5828-50 must be enabled
for 1284 mode compatibility.
Selects the Ethernet transmission speed.
[0x00 ~ 0x03 / 0x00 / 0x01 step]
Bit 1 Bit 2 Speed
0
0
Auto Sense
0
1
10Base-T
1
0
100Base-T
1
1
Auto
When the printer is powered off, spooled print
jobs on the hard disk remain there until the next
time the printer is powered on. This setting
determines whether to print spooled jobs from
the previous printing session the next time the
printer is powered on.
[0 ~ 1 / 1 / 1 step]
0: Job clear. Clears spooled jobs on the hard
disk when the printer is switched on.
1: Print jobs. Prints spooled jobs on the hard
disk when the printer is powered on.
IEEE 1394 settings.
5-23
Advertisement
Table of Contents
