Programmed Playback; Setting The Program - Tascam CD-200 Owner's Manual

An indicator for the current mode will appear on the display as
shown below.
Display
No indication
SHUFFLE
MEMORY
The selected playback mode is retained even when the power is
turned off.
NOTE
• Immediately after pressing the PLAY MODE/INTRO CHECK
key, the selected mode is shown on the main display area as
follows.
Continuous playback mode set: CONTINUE
Shuffle playback mode set: SHUFFLE
Programmed playback mode set: PROGRAM
• In this manual, unless stated otherwise, explanations are
given assuming that continuous playback mode is set.
Playback mode
Continuous playback
Shuffle playback

Programmed playback

4 − Playing back CDs
Programmed playback
To use programmed playback, you must set a program either
before or after setting the playback mode to programmed
playback mode. (See "Select the playback mode" on page 18.)
When in programmed playback mode, press the PLAY/READY
key on the main unit or the remote control to start playback of
the set program in order from the first track (program step 01).
Press a SEARCH Ô/ (Â/¯) key on the main unit or a
search (Ô/Â, ¯/) key on the remote control to skip
to the previous or next program step.
In programmed playback mode, when playback is stopped the
total number of tracks in the program and the total program
time are shown (total program time is not shown when using a
data CD).

Setting the program

When no program is set, follow the procedures below to set a
program using the remote control.
NOTE
• The program cannot be set from the main unit.
• You can set a program at any time regardless of the current
playback mode.
• The program is cleared when the disc tray is opened.
1. Press the PROGRAM EDIT key while playback is stopped.
The unit enters program setting mode, and if no program
has been set, it will be possible to set a track to program step
01 (MEMORY indicator blinks).
[Audio CD]
PROGRAM
EDIT key
19
TASCAM CD-200