5.4.1
GTP 59 Removal
Remove the GTP 59 using the following procedure:
1. Remove power from the GI 275 that is directly interfaced to the GTP 59.
2. Remove the mounting nut shown in Figure 5-5.
3. Remove the GTP 59 from the hole.
5.4.2
GTP 59 Re-installation
Re-install the GTP 59 using the following procedure:
1. Place the GTP 59 in the previous installation hole.
2. Install washer and nut and torque to specifications in Figure 5-5.
5.4.3
GTP 59 Checkout
Perform the OAT Checks in Section 5.9.3.
190-02246-C2
Rev. 3
GI 275 Part 27 AML STC Maintenance Manual
Page 5-10