Table of Contents
Advertisement
Useful Information
Battery recharge
Problem
The handset beeps and/or
flashes.
I fully charged the
batteries, but
–
still flashes or
– the operating time
seems to be shorter.
Making/answering calls, intercom
Problem
is displayed.
Noise is heard, sound cuts
in and out.
The handset or base unit
does not ring.
I cannot make local calls
with the handset using a
mobile line.
64
TGH26xE_(en)_0203_ver120.pdf 64
Cause/solution
R Battery charge is low. Fully charge the batteries (page 12).
R Clean the battery ends (
a dry cloth and charge again.
R It is time to replace the batteries (page 11).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 68).
R Activating eco mode reduces the range of the base unit in
standby mode. If required, turn eco mode off (page 17).
R You are using the handset or base unit in an area with high
electrical interference. Re-position the base unit and use the
handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for details.
R The ringer volume for landline is turned off. Adjust ringer
volume (page 36).
R The ringer volume for mobile line is turned off. Adjust the
ringer volume (page 34).
R When one handset is selected to ring for mobile calls, other
units do not ring. To change the selection, see page 19.
R Do not disturb mode is turned on. Turn it off (page 40).
R You need to add your area code when making mobile calls.
Store your area code in order to automatically add it to the
beginning of phone number when making mobile calls
(page 21).
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
,
) and the charge contacts with
2017/02/03 14:07:10
Advertisement
Table of Contents
