Table of Contents
Advertisement
Link to Mobile
Link to mobile feature
You can connect your base unit and mobile
phone using Bluetooth wireless technology, so
that you can make or answer mobile calls
using your phone system. This allows you to:
– use the unit to talk on mobile calls even if
some areas of your home have poor mobile
reception, simply by placing your mobile
phone in an area with good reception.
– talk on mobile calls even if your mobile
phone is in your pocket or bag.
– enjoy cordless mobile calls even if your
mobile phone plugged in and charging.
Important:
R Your mobile phone must support the Hands
Free Profile (HFP) specification.
R You may pair 2 mobile phones and 1
headset.
R The unit can be used to talk on 2 lines at
the same time (for example, 2 mobile lines,
or the landline and 1 mobile line).
R Only 2 Bluetooth devices can be used with
the unit at the same time (for example, 2
mobile lines, or the headset and 1 mobile
line).
R Locate your mobile phone near the base
unit. If the mobile phone is too close to the
base unit during a mobile call, you may
hear noise. For best performance, we
recommend placing the mobile phone
between 0.6 m to 3 m away from the base
unit.
Pairing a mobile phone
Important:
R Before pairing a Bluetooth enabled mobile
phone to the base unit, make sure that no
other Bluetooth device such as a Bluetooth
headset is connected to your mobile phone.
1
Handset:
For MOBILE 1: MMENUN (right soft key)
#6241
For MOBILE 2: MMENUN (right soft key)
#6242
R After the corresponding MOBILE
indicator on the base unit starts
18
TGH26xE_(en)_0203_ver120.pdf 18
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
flashing, the rest of the procedure must
be completed within 5 minutes.
2
Your mobile phone:
While the corresponding MOBILE
indicator is flashing, follow the instructions
of your mobile phone to enter the pairing
mode.
R Depending on your mobile phone, it
may ask you to enter the Bluetooth
PIN (default: "0000"). If your mobile
phone shows PassKey confirmation on
its display, follow the directions to
proceed.
3
Handset:
Wait until a long beep sounds.
R It may take more than 10 seconds to
complete pairing.
R When the corresponding MOBILE
indicator lights up, the mobile phone is
connected to the base unit. You are
ready to make mobile calls.
4
M
N
Note:
R Make sure that your mobile phone is set to
connect to this product automatically. Refer
to your mobile phone's operating
instructions.
R Make sure you cancel your mobile phone's
current pairing if you want to pair it to the
other line (page 18).
R The default setting for the SMS alert feature
is "On", so when you pair your mobile
phone to the base unit, this feature may be
activated (page 49). (This depends on the
version and type of mobile phone you are
using.)
Unpairing a mobile phone
You can cancel the pairing of a mobile phone
that is stored in the base unit.
1
For MOBILE 1: MMENUN (right soft key)
#6111
For MOBILE 2: MMENUN (right soft key)
#6112
2
MbN: "Yes" a MOKN
R When the mobile phone is unpaired,
the MOBILE indicator is turned off.
3
M
N
2017/02/03 14:07:08
Advertisement
Table of Contents
