Table of Contents
Advertisement
Problem
I cannot connect a mobile
phone to the base unit.
I cannot hear a dial tone.
I cannot use the Smart
Function Key even if the
indicator is flashing
slowly.
I cannot use the intercom
feature.
The base unit beeps.
Menu list
Problem
I cannot activate the eco
mode.
I cannot register a handset
to a base unit.
I cannot remember the
PIN.
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
TGH26xE_(en)_0203_ver120.pdf 63
Cause/solution
R Confirm that your mobile phone is turned on.
R Confirm that your mobile phone is within base unit range
(page 14).
R Your mobile phone's Bluetooth feature is turned off. Turn it on.
R Depending on the state of the wireless environment, such as
the presence of any electrical interference, there may be a
delay even if the auto connection feature is turned on. You can
connect to the base unit manually (page 20).
R The mobile phone has not been paired to the base unit. Pair
the mobile phone (page 18).
R Make sure that you are using the supplied telephone line cord.
Your old telephone line cord may have a different wiring
configuration.
R The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
R Disconnect the base unit from the telephone line and connect
the line to a known working telephone. If the working
telephone operates properly, contact our service personnel to
have the unit repaired. If the working telephone does not
operate properly, contact your service provider/telephone
company.
R Another unit is in use. Wait and try again later.
R The key lock feature is turned on. Turn it off (page 26).
R This feature is available between the handsets. Although the
handset displays "Intercom", this feature is not available for
single handset models.
R New messages have been recorded. Listen to the new
messages (page 53).
Cause/solution
R You cannot set eco mode when you set the repeater mode
"On". If required, set the repeater mode to "Off" (page 45).
R You entered the wrong PIN. If you forget your PIN, see "I
cannot remember the PIN." (page 63).
R Change the PIN using the following method.
1
MMENUN (right soft key) #132
2
*7000
3
Enter the new 4-digit base unit PIN. a MOKN
4
MbN: "Yes" a MOKN a M
Useful Information
N
63
2017/02/03 14:07:10
Advertisement
Table of Contents
