Ink Absorber Counter Setting; User Mode - Canon PIXMA mini260 Service Manual

(3) Ink absorber counter setting

When the logic board ass'y is replaced, reset the ink absorber counter. In addition, according to the ink absorber counter
value, replace the ink absorber (ink absorber kit). The standard counter value for ink absorber replacement is given
in the table below.
Ink absorber counter value
Less than 7%
7% or more
*1: Check the ink absorber counter value by service test print or EEPROM information print.
[See 3-3. Adjustment / Settings, (5) Service mode, for details.]

(4) User mode

Function
Print head manual cleaning
Print head deep cleaning
Paper feed roller cleaning
Nozzle check pattern printing
Print head alignment
Bottom plate cleaning
Print head replacement
<Standalone printer operation>
1) Turn on the printer.
2) Press and hold the Stop/Reset button until the Power LED blinks the specified number of times listed in the table below, and release
it. The operation starts.
LED blinking
8 times Infrared communication mode
*1
Procedures
- Cleaning Color:
Perform via the printer operation panel, or from the
printer driver Maintenance tab.
See "Standalone printer operation" below.
- Cleaning Color:
Perform via the printer operation panel, or from the
printer driver Maintenance tab.
See "Standalone printer operation" below.
Perform via the printer operation panel.
See "Standalone printer operation" below.
Perform via the printer operation panel, or from the
printer driver Maintenance tab.
See "Standalone printer operation" below.
Perform via the printer operation panel, or from the
printer driver Maintenance tab.
See "Standalone printer operation" below.
Perform via the printer operation panel.
See "Standalone printer operation" below.
The print head is replaceable at the same position as for
ink tank replacement. (Open the printer cover. When
the carriage stops at the center, the print head can be
replaced.)
Operation
<Part 1: 3-3. Adjustment / Settings, (1) to (4)>
Ink absorber kit replacement
Not required.
Required.
Automatic and manual print head alignment
available via the printer operation panel or
the printer driver Maintenance tab.
Cleaning of the platen ribs when the back
side of paper gets smeared.
1-19
Remarks
Remarks