Canon PIXMA mini260 Service Manual page 14

*1: For print head alignment, use Matte Photo Paper (MP-101) or Photo Paper Plus Glossy (PP-101).
General notes:
- Make sure that the flexible cables and wires in the harness are in the proper position and connected correctly.
See 3-2. Special Notes on Repair Servicing, (1) Flexible cable and harness wiring, connection.
- Do not drop the ferrite core, which may cause damage.
- Protect electrical parts from damage due to static electricity.
- Before removing a unit, after removing the power cord, allow the printer to sit for approx. 1 minute (for capacitor discharging to
protect the logic board ass'y from damages).
- Do not touch the timing slit strip film and timing slit disk. No grease or abrasion is allowed.
- Protect the units from soiled with ink.
- Protect the housing from scratches.
- Exercise caution with the screws, as follows:
i. The screws of the paper feed motor may be loosened only at replacement of the paper feed motor unit (DO NOT
loosen them in other cases).
ii. DO NOT loosen the red screws on both sides of the main chassis, securing the carriage shaft positioning (they are
not adjustable in servicing)
For Germany:
A lithium battery is installed in the mini260. Please be cautious of the following:
- At repair:
Risk of explosion if battery is replaced by an incorrect type.
Explosionsrisiko, falls Batterie nicht mit vorgeschriebenem Baterrietypus ersetzt wird.
- At disposal:
Dispose of used batteries according to the local regulations.
Batterienentsorgung gemaess lokalen Vorschriften.
When the Service Manual issued by CINC is localized, be sure to include the above cautions (at repair and disposal) in German.
For California, U.S.A.:
Included battery contains Perchlorate Material-special handling may apply.
See http://www.dtsc.ca.gov/hazardouswaste/perchlorate/ for detail.
<Part 1: 3-1. Notes on Service Part Replacement>
1-10