Canon PIXMA mini260 Service Manual page 25

*1: If the LED does not light in blue (the printer does not enter the service mode), disconnect the power cord and plug it again. Then
start from step 1) to start the printer in the service mode again. If the automatic power-on function is enabled in the printer, the
printer enters the service mode for the first time, but it will never enter the service mode if the printer is turned off by the
ON/OFF button. This is because the printer remains to be turned on internally if the power is turned off by the ON/OFF button.
To prevent this, disconnection of the power cord is required before starting the printer in the service mode.
*2: If the Stop/Reset button is pressed 15 or more times, the Alarm LED (orange) or Power LED (blue) lights steadily without any
changes.
<Destination settings>
In the destination settings mode, press the Stop/Reset button the specified number of time(s) according to the destination listed in the table
below, and press the ON/OFF button.
Time(s)
0 times
1 time
2 times
3 times
4 times
5 times
6 times
7 times
8 times
9 times or more
Note: After setting the destination, confirm the model name and destination in service test print or EEPROM information print.
[See 3-4. Verification Items,
<Button and LCD test>
Confirm the operation after replacement of the operation panel unit, or LCD unit.
1) In the button and LCD test mode, press the Stop/Reset button. The LCD turns blue, waiting for a button to be pressed.
2) Press each button of the operation panel, except the Power, Stop/Reset, and OK buttons (total 12 buttons).
3) Only one button should be pressed at one time. If 2 or more buttons are pressed at the same time, only one of them is considered to
be pressed, and the other buttons are ignored.
The LCD is divided into 12 segments, representing each button. The color of a segment corresponding to the pressed button changes to red.
When all the buttons are pressed, the entire LCD changes to a full red screen.
The buttons to be pressed are:
- NAVI button
- HOME button
- Back button
- Function buttons (f1) / (f2)
- Up / down / left / right cursor buttons
- + / - buttons
- Print button
LED indication
Blue (Power) No change of the destination
Orange (Alarm) Japan
Blue (Power) Korea
Orange (Alarm) US
Blue (Power) Europe
Orange (Alarm) Australia
Blue (Power) Asia
Orange (Alarm) China
Blue (Power) Taiwan
Orange (Alarm) Return to the menu selection
(1) Service test print, or (2) EEPROM information
1-21
Destination
print.]