Canon PIXMA mini260 Service Manual page 27

6-4) Press the OK button.
6-5) The printer enters the LCD flicker adjustment mode.
6-6) Press the OK button again, then the ON/OFF button, to exit the button and LCD test and return to the service mode menu selection.
<LF / Eject correction>
After replacement of the paper feed roller ass'y, eject roller ass'y, or logic board in repair servicing or in refurbishment
operation, perform the adjustment.
Details: Print the LF / Eject correction pattern on 3 sheets of paper. Select the Pattern No. (0 to 2) in which streaks or lines are the
least noticeable, press the Stop/Reset button the same number of time(s) as the selected Pattern No., then press the
ON/OFF button.
1) In the LF /Eject correction mode, press the Stop/Reset button the specified number of time(s) according to the destination listed in
the table below, then press the ON/OFF button. (Set 3 sheets of Glossy Photo Paper GP-401 in the ASF.)
Time(s)
1 time Japan
2 times Others
Note: - Each time the Stop/Reset button is pressed, the Alarm and Power LEDs light alternately, Alarm in orange and Power in blue.
- If the Stop/Reset button is NOT pressed, and only the ON/OFF button is pressed, the printer remains in the LF / Eject correction
mode.
- If the Stop/Reset button is pressed 3 times or more, then the ON/OFF button is pressed, the printer returns to the service mode
menu selection.
2) The LF / Eject correction pattern is printed. (LF correction values from 0 to 2 in the upper half, Eject correction values from A to C
in the lower half )
3) In the printout, select the Pattern No. in which streaks or lines are the least noticeable for LF correction and Eject correction
respectively , press the Stop/Reset button the same number of time(s) as the selected Pattern No., then press the ON/OFF button.
How to determine the selection:
a. Select the pattern with no streaks or lines.
Destination
L size
4" x 6"
Paper size
1-23