Samsung P560 Service Manual page 32

- 이 문서는 삼성전자의 기술 자산으로 승인자만이 사용할 수 있습니다 -
- This Document can not be used without Samsung's authorization -
2. Introduction and Specification
Boot
Boot Device Priority
• Select system boot options.
NumLock
• Selects Power-on state for Numlock.
Enable Keypad
• Select a method of Keypad.
- [Only By Fn Key] : Leave the embedded keypad disabled when the Numlock LED is on.
- [By NumLock] : Enable the embedded keypad when Numlock LED is on and no external keyboard is attached.
Summary Screen
• Display system configuration on boot.
Boot-time Diagnostic Screen
• Display the diagnostic screen during boot.
PXE Oprom
• This selects whether network boot PXE will be loaded or not during the POST.
- [Only with F12] : The network boot PXE will be loaded only if F12 is pressed during the POST.
- [Always] : The network boot PXE will be always loaded during the POST.
Brightness Control Mode
• [Auto] : The brightness values are set by the status of AC adapter at each bootup.
• [User Control] : The brightness values could be remained regardless of the status of AC adapter.
Wireless Device Control
• [Always On / Off] : The wireless devices are turned on or not.
• [Last Status] : The wireless devices are restored to last status.
Smart Battery Calibration
• If you select this option, the system battery will be discharged completely for more accurate battery level detection.
This option only works with SMART battery.
Main Advanced
 Boot Device Priority
NumLock
Enble Keypad
Summary screen
Boot-time Diagnostic Screen
PXE OPROM
Brightness Mode Control
Wireless Device Control
Smart Battery Calibration
F1
Help 
ESC
Exit 
Phoenix SecureCore(tm) Setup Utility
Security
[OFF]
[By NumLock]
[Disabled]
[Disabled]
[Always]
[Auto]
[Always On]
F5/F6
Select Item
Enter
Select Menu
TPM State Boot
Change Values
Select  Sub-Menu
2-28
Exit
Item Specific Help
Select system boot
options
F9
Setup Defaults
F10
Save and Exit