Yamaha MusicCast R-N2000ASL User Manual page 40

PREPARATION > Turning the product ON
"Wireless WAC" Display
The WAC (Wireless Accessory Configuration) function is for applying the wireless settings of an iOS device to another device and
(
wirelessly connecting to the network. The steps for connecting to a network using MusicCast Controller are explained in the
chapter "PREPARATION". Therefore, how to cancel WAC is explained here.
The WAC message is displayed the first time you use the product and after it is initialized.
(
NOTE
It takes several seconds from turning the power ON until audio is played.
(
After turning the power OFF, do not try to turn it ON again for at least 10 seconds. Doing so may generate some noise.
(
Related links
"Making a wireless connection with your iPhone (WAC)" (p.134)
n
Operating the power with the remote control
When the z (Power) Switch on the front panel is up, each press of the zAMP key on the remote control
switches the power of this product between ON and Standby.
NOTE
When the power of this product is in Standby, to turn the power ON without using the remote control, flip the z (Power) Switch down
for a moment and then back up.
40