Installing The Antenna; Installing The Belt Clip - Kenwood ProTalk TK-3710 User Manual

INSTALLING THE ANTENNA

Screw the antenna into the connector on the top of the
transceiver by holding the antenna at its base and turning it
clockwise until secure.

INSTALLING THE BELT CLIP

If necessary, attach the belt clip using the two
supplied M3 x 8 mm binding screws.
Note:
◆ If the belt clip is not installed, its mounting
location may get hot during continuous
transmission or when left sitting in a hot
environment.
◆ Use the Phillips #2 screwdriver.
CAUTION
◆ Do not use glue which is designed to prevent screw loosening when installing
the belt clip, as it may cause damage to the transceiver. Acrylic ester, which
is contained in these glues, may crack the transceiver's back panel.
5
Antenna
Belt clip
M3 x 8 mm
screws