Table of Contents
Advertisement
INSTALLING/ REMOVING THE BATTERY PACK
The battery pack is not charged at the factory; charge it before use.
1
Align the battery pack with the back of the
transceiver, then press the battery pack and
transceiver firmly together until the release latch on
the base of the transceiver locks.
2
To remove the battery pack, lift the safety catch on
the base of the transceiver, then press the release
latch underneath the safety catch.
3
While pressing the release latch, pull the battery
pack away from the transceiver.
CAUTION
◆ Do not short the battery terminals or dispose of the battery by fire.
◆ Never attempt to remove the casing from the battery pack.
◆ Do not remove the black sheet from the reverse side of the transceiver (refer
to the illustration below). Removal of this sheet decreases the waterproof
efficiency of the transceiver and may cause malfunctions if water seeps into
the transceiver.
◆ Use KNB-84L battery pack (Supplied battery) to maintain IP67 performance.
PREPARATION
4
Advertisement
Table of Contents
