Installing The Antenna; Installing The Belt Clip - Kenwood TK-5400 Instruction Manual

KENWOOD CORPORATION
FCC ID: ALH33063110

Installing the Antenna

Screw the antenna into the connector on the top of the transceiver by holding the
antenna at its base and turning it clockwise until secure.

Installing the Belt Clip

If necessary, attach the belt clip using the two supplied 3 x 6 mm
screws.
Note:
If the belt clip is not installed, its mounting location may get hot
during continuous transmission or when left sitting in a hot
environment.
Installing the Cap over the Universal
Connector
If you are not using the optional KMC-25 speaker/ microphone, install
the cap over the universal connector using the supplied 4 x 6 mm
screw.
Note:
To keep the transceiver water resistant, you must cover the universal
connector with the cap or the speaker/ microphone connector.