Table of Contents
Advertisement
Power Profile
Table 8: IQ Engine Status LED Activity
LED State
Dark
Solid white
Slow-blinking
white
Solid amber
Slow-blinking
amber
Fast-blinking
amber
Table 9: ExtremeWireless WiNG Status LED Activity
LED State
Dark
Solid white
Slow-blinking white
Flashing fading white
Solid amber
Fast-blinking amber
Power Profile
The following table shows the AP3000X power profile. Use this information when you
plan your installation.
Table 10: AP3000X power profile
AP3000X
Radio 1
Radio 2
BLE
USB (2.5W)
14
ExtremeWireless™ AP3000X Access Point Installation Guide
Description
AP is not being powered.
Power is on and the access point is ready to use. The AP has
a Control And Provisioning of Wireless Access Points (CAPWAP)
connection to ExtremeCloud IQ.
The AP has a CAPWAP connection to ExtremeCloud IQ, but it is
operating on 802.3af power instead of 802.3at power.
The power is on and the access point is in start-up mode, or is
running without a CAPWAP connection.
The AP does not have a CAPWAP connection to ExtremeCloud IQ.
It is operating on 802.3af power instead of 802.3at power.
A IQ Engine firmware upgrade is in progress.
AF profile
2×2 (18 dBm)
2×2 (18 dBm)
On
Off
Description
The AP is not being powered or the LED is
turned off from the controller.
The AP is starting up and a connection
is being established to ExtremeCloud IQ
Controller.
The controller is taking over the AP or the
controller has failed to take over the AP.
A location aid to help you find an AP. This
setting is configured from the controller.
A firmware upgrade is in progress.
The AP is acquiring Dynamic Host
Configuration Protocol (DHCP) IP address.
AT and DC profile
2×2 (18 dBm)
2×2 (18 dBm)
On
On
AP3000X Overview
Advertisement
Table of Contents
