Advertisement
Chapter 6: Device Configuration
Select + Add Row below the Network Time Protocol (NTP) table to define the configurations of NTP
4
server resources the used it obtain system time by the access point's profile. Set the following
parameters to define the NTP configuration:
AutoKey
Key
Prefer
Server IP
Version
5 Select OK to save the changes made to the general profile configuration. Select Reset to revert to the
last saved configuration.
Profile Radio Power
Use the Power screen to set one of two power modes (3af or Auto) for the access point profile. When
Automatic is selected, the access point safely operates within available power. Once the power
configuration is determined, the access point configures its operating power characteristics based on its
model and power configuration.
An access point uses a complex programmable logic device (CPLD). The CPLD determines proper
supply sequencing, the maximum power available and other status information. One of the primary
functions of the CPLD is to determine the maximum power budget. When an access point is powered
on (or performing a cold reset), the CPLD determines the maximum power provided by the POE device
64
Select the radio button to enable an autokey configuration for the NTP
resource. The default setting is disabled.
If an autokey is not being used, manually enter a 64 character maximum key
the access point and NTP resource share to securely interoperate.
Select the radio button designate this particular NTP resource as preferred.
If designating multiple NTP resources, preferred resources will be given first
opportunity to connect and provide NTP calibration.
Set the IP address of each server added as a potential NTP resource.
Use the spinner control to specify the version number used by this NTP
server resource. The default setting is 0.
Altitude
TM
4000 Series Access Point System Reference Guide
Advertisement
