Table of Contents
Advertisement
English
4
Transport
CAUTION!
Risk of injury when lifting and setting down the load. Risk of
crushing!
Do not stand under the load when lifting and setting
down.
CAUTION!
Risk of injury if unsuitable lifting devices are used incorrectly.
Risk of falling and crushing!
People may only stand outside the danger area.
(Germany: DGUV regulation 100-500 Chap. 2.3)
Observe the load capacity of the lifting devices and slings
used. (Germany: DGUV regulation 100-500 Chap. 2.8)
CAUTION!
Risk of the heat pump tipping over if unsuitable attachment
points are used. Risk of falling and crushing!
The heat pump may only be lifted from the operator side
with a lift truck or forklift.
CAUTION!
Work may only be carried out on the device outdoors in dry
weather conditions. Risk of damage to the device or electric
shock!
In wet weather conditions such as rain, snow etc., the
housing of the heat pump must be kept properly closed
CAUTION!
Do not stand near the device during storms. Risk of lightening!
Do not stand in the immediate vicinity of the heat pump.
CAUTION!
Weather-related conditions on transport routes. Risk of injury
due to slipping!
Transport routes must be kept clear and weather-related
conditions such as ice and snow must not impair safe
transport.
CAUTION!
The heat pump must not be tipped during transport. The
machine must be secured to prevent the risk of tipping.
A pallet should be used to transport the heat pump to its final
installation location. The basic device can be transported with a
lift truck, hand truck or by means of 3/4" pipes fed through the
holes in the baseplate or frame.
EN-6
Before using the transport holes in the frame, it is necessary to
remove the lower side panel assemblies. This is done by loosen-
ing each of the two screws at the base and then withdrawing
the panels by unhooking them from above. Rehang the panels
by gently pushing them in an upwards direction.
Be careful not to damage any components when inserting the
pipes through the frame.
Any transport holes are to be covered at the installation location
using the 8 black dust caps, which are included in the device's
accessories pack.
1.
After transportation, the transport fastening in the device is to
be removed from both sides of the base.
NOTE
Before commissioning, the transport fastening must be
removed.
452170.66.01-EN · FD 0303
3.
1.
2.
Opening the cover
LI 1422C - 1826C
1.
1.
3.
2.
Closing the cover
Remove
(2 screw)
transport lock
www.dimplex.de
Advertisement
Table of Contents
