Table of Contents
Advertisement
80
EN
After Use
1
Turn off the camcorder.
2
Slide and hold OPEN/EJECT in the direction of
the arrow, then pull the cassette holder cover
open until it locks. The cassette holder opens
automatically. Remove the cassette.
3
Press "PUSH HERE" to close the cassette holder.
•Once the cassette holder is closed, it recedes
automatically. Wait until it recedes completely
before closing the cassette holder cover.
4
Slide BATT. RELEASE
2
pack
.
PUSH HERE
OPEN/EJECT
Switch
Cassette
holder cover
Downloaded from:
1
and remove the battery
Remove.
Cassette holder
1
2
BATT. RELEASE
Switch
https://www.usersmanualguide.com/
USER MAINTENANCE
Cleaning The Camcorder
1
To clean the exterior, wipe gently with a soft
cloth.
Put the cloth in diluted mild soap and wring it
well to wipe off heavy dirt. Then wipe again
with a dry cloth.
2
Press PUSH OPEN and open the LCD monitor.
Wipe gently with a soft cloth. Be careful not to
damage the monitor. Close the LCD monitor.
3
To clean the lens, blow it with a blower brush,
then wipe gently with lens cleaning paper.
4
To clean the viewfinder, raise it to the vertical
position. Carefully lift the plastic tab on the
1
bottom of the viewfinder, and open the hatch
.
5
Insert a lens blower or soft cloth into the gap at
the bottom of the viewfinder and clean the
interior of the viewfinder with it
6
Close the hatch. Tilt the viewfinder back to the
horizontal position and push it back in.
NOTES:
● Avoid using strong cleaning agents such as benzine
or alcohol.
● Cleaning should be done only after the battery
pack has been removed or other power units have
been disconnected.
● Mould may form if the lens is left dirty.
● When using a cleaner or chemically treated cloth
refer to the cautions of each product.
1
Hatch
2
.
2
Lens blower
Advertisement
Table of Contents
