JVC GR-DV1800 Instructions Manual page 75

SYMPTOM
17. The Dissolve function does
not work.
18. The Picture Wipe and
Dissolve functions do not
work.
19. The picture wipe function
does not work.
20. Scene transition does not
go as expected.
Downloaded from:
17. •The Sepia, Monotone or
•"WIDE MODE" is set to
•The previously selected
18. •The last selected editing
•At the end of the last selected
•The power is off.
19. •The Slow Shutter mode is
•"WIDE MODE" is not set to
20. •When using "Picture Wipe/
https://www.usersmanualguide.com/
POSSIBLE CAUSES
Slow Shutter mode of
Programme AE with special
effects is activated.
"SQUEEZE" or "PS-WIDE" in
the Menu Screen.
mode of Programme AE with
special effects was changed
after the last selected scene
for editing was registered.
scene is ending.
scene for editing, the Power
Switch was set to "OFF".
activated.
"OFF".
Dissolve" ( pg. 32), there
is a delay of a fraction of a
second between the previous
record stop-point and the
Dissolve start-point. This is
normal, but this slight delay
becomes especially
noticeable when shooting
fast-moving subject or during
rapid panning.
CORRECTIVE ACTION
17. •Turn off Sepia, Monotone or
Slow Shutter before adding
Dissolve to a scene
transition ( pg. 32, 34).
•Set "WIDE MODE" to
"CINEMA" or "OFF" mode
( pg. 28).
•Make sure you have selected
the mode of Programme AE
with special effects you want
before starting editing
( pg. 32, 34).
18. •Select Picture Wipe or
Dissolve before beginning
recording. The effects are
then automatically activated
( pg. 32).
•Do not turn off the
camcorder's power after
setting Edit-In and Edit-Out
points, as they will all be
erased ( pg. 32).
•The camcorder automati-
cally shuts off after 5
minutes have elapsed in the
Record-Standby mode.
Make sure you continue
operations within 5 minutes
after engaging Record-
Standby mode (
19. •Disengage the Slow Shutter
mode or set "WIDE MODE"
to "OFF" before preparing
to use the Picture Wipe
( pg. 28, 32, 34).
20.
————
CONTINUED ON NEXT PAGE
75
EN
pg. 32).