Table of Contents
Advertisement
BEEP
TALLY
DEMO
MODE
ON
SCREEN
DATE/
TIME
TIME
CODE
CLOCK ADJ.
QUALITY
SIZE
UXGA
: Factory-preset
NOTES:
● "
SYSTEM" and "
applied when the Power Switch is set to "
Switch is set to "
● The "
DISPLAY" settings are effective even when the Power Switch is set to "
● The "ON SCREEN" setting can also be changed by pressing the DISPLAY Button on the remote control
(provided) (
Downloaded from:
OFF
Even though not heard while shooting, shutter sound is recorded on the tape.
The beep sounds when the power is turned on or off, and at the beginning and end
BEEP
of recording. Also to activate the shutter sound effect (
Instead of a beep, a melody sounds when any operation is performed. It also
MELODY
activates the shutter sound effect (
The tally lamp remains off at all times.
OFF
ON
The tally lamp comes on to signal the start of recording.
OFF
Automatic demonstration will not take place.
Demonstrates certain functions such as Programme AE with special effects,
ON
etc., and can be used to confirm how these functions operate. When "DEMO
MODE" is set to "ON" and the Menu Screen is closed, demonstration starts.
Performing any operation during the demonstration stops the demonstration
temporarily. If no operation is performed for more than 1 minute after that,
the demonstration will resume.
NOTES:
● If a tape is in the camcorder, the demonstration cannot be turned on.
● "DEMO MODE" remains "ON" even if the camcorder power is turned off.
● If "DEMO MODE" remains "ON", some functions will not be available.
After viewing demo, set to "OFF".
Keeps the camcorder's display (except the date, time and time code) from
LCD
appearing on the connected TV screen.
Makes the camcorder's display appear on screen when the camcorder is
LCD/TV
connected to a TV.
The date/time does not appear.
OFF
Displays the date/time for approx. 5 seconds in the following cases:
AUTO
•When the Power Switch is set from "OFF" to "
•When video playback starts. The camcorder displays the date/time when
scenes are recorded.
•When the date is changed during video playback.
The date/time is always displayed.
ON
Time code is not displayed.
OFF
Time code is displayed on the camcorder and on the connected TV. Frame
ON
numbers are not displayed during recording.
Allows you to set the current date and time (
Refer to "Picture Mode Setting" (
DISPLAY" functions which are set when the Power Switch is set to "
".
pg. 53, 56, 66).
https://www.usersmanualguide.com/
pg. 18, 19).
pg. 14).
" (
pg. 39). "CLOCK ADJ." only appears when the Power
EN
pg. 18, 19).
" or "
".
pg. 9).
" are also
".
29
Advertisement
Table of Contents
