Siemens SIMATIC NET SCALANCE XF-200BA Operating Instructions Manual page 28

Description of the device
3.4 SET button
Position
The "SET" button is located on the front of the SCALANCE XF-200BA.
Figure 3-2
Resetting the device to factory defaults
NOTICE
Previous settings
If you reset, all the settings you have made will be overwritten by factory defaults.
NOTICE
Inadvertent reset
An inadvertent reset can cause disturbances and failures in a configured network with further
consequences.
Requirement
• The device is in operation.
• The function "Restore Factory Defaults" is enabled for the "SET" button.
Note
Resetting despite disabled "SET" button
If you have disabled the "Restore Factory Defaults"function for the "SET" button in the
configuration, this does not apply during the startup phase, see section "Restoring the
factory settings (Page 58)"
If the function has been disabled in the configuration, it is only disabled on completion of the
startup phase.
28
Position of the "SET" button on the SCALANCE XF-200BA
Operating Instructions, 02/2023, C79000-G8976-C470-08
SCALANCE XF-200BA