Table of Contents
Advertisement
ASSEMBLY
Cutting Attachment to Drive Shaft Installation
Saw Chain is sharp! Always wear gloves when handling
assembly, otherwise serious personal injury may result
1.
Loosen the two (2) screws (A)
and remove locator screw (B)
on cutting attachment.
2.
Loosen clamp knob (E).
3.
Pull upper tube (F) out of
fiberglass lower tube 127-152
mm (5-6 in.), then slide (F)
back into fiberglass lower tube
exposing inner drive shaft (G).
Align and join star shaped drive
end of inner drive shaft (G) with
cutting attachment shaft (H).
4.
Align ridges (J) on upper tube
with seams in cutting
attachment.
18
G
F
G
J
J
© 06/21 ECHO Incorporated
PPT-226LA
A
A
B
E
H
X7712090701
Advertisement
Table of Contents
