Air Filter - Echo Power Pruner PPT-266LA Operator's Manual

PPT-226LA

Air Filter

Level 1
Parts Required: Air Filter.
1. Close choke (Cold Start
Position [
dirt from entering the carburetor
throat when the air filter is
removed. Brush accumulated
dirt from air cleaner area.
2. Remove air filter cover and air
filter retainer from inside cover.
Brush dirt from inside cover.
3. Replace filter if it is damaged,
very dirty, or the rubber sealing
edges are deformed.
4. Remove foam pre-filter and air
filter and clean as indicated
below.
5. Foam Pre-filter
• Clean foam filter in water/
detergent solution and rinse
with clean water.
• Wrap the filter in a clean, dry
cloth and squeeze (do not
wring) dry. Allow to dry
completely before reuse. Do not oil.
Dual Layer Air Filter
• Lightly brush debris from filter.
• Soak heavily soiled filters in water/detergent solution to loosen dirt,
then brush lightly.
• Rinse with clean water and allow to dry completely before reuse.
6. Place foam pre-filter over raised center and inside outer lip of air filter.
Install air filter in air filter case.
7. Install air filter retainer on post in air filter cover, flat side up.
8. Install air filter cover and tighten cover knob securely.
X7712090701
© 06/21 ECHO Incorporated
]). This prevents
MAINTENANCE
31