Care And Maintenance; Inspection; Cleaning The Equipment; Lubrication - True RC900 Owner's Manual

CARE AND MAINTENANCE

It is important to perform the minor maintenance tasks described in this section. Failure to maintain the bike as described
here could void the TRUE Fitness Warranty. *To reduce the risk of electrical shock, always unplug the unit from its power
source before cleaning or performing any maintenance tasks.*

INSPECTION

TRUE Fitness is not responsible for performing or scheduling regular maintenance or inspections. Users should inspect
the bike daily. Look and listen for slipping belts, loose fasteners, unusual noises, worn or frayed power cords, and any
other indications that the equipment may be in need of service. If any of these are noticed, obtain service. Do not attempt
to use the bike until proper service has been performed or damaged parts have been replaced.
IMPORTANT!
If you determine that the bike needs service, make sure that the bike cannot be used inadvertently. *Turn the unit off , and
then unplug the power cord from its power source.* Make sure other users know that the bike needs service. To order
parts or to contact a TRUE Authorized Service representative, please visit www.truefi tness.com.

CLEANING THE EQUIPMENT

AFTER EACH USE:
• Use GymWipes™ Antibacterial wipes or spray a solution of 30 parts water to 1 part mild detergent to dampen a soft
cloth and wipe all exposed surfaces.
• Use a LCD/screen cleaner or spray a solution of 1 part 91% isopropyl alcohol and 1 part water to dampen a soft cloth
and wipe the surface of the console. This helps remove fi ngerprints, dust, and dirt.
WEEKLY:
• Vacuum any dust or dirt that might have accumulated under or around the bike. Clogged air vents can prevent
adequate cooling, causing a shortened life.
CAUTION:
!
• Do not use any acidic cleaners. Doing so will weaken the paint or powder coatings and may void the TRUE Fitness
Warranty.
• Never pour water or spray liquids on any part of the bike.
• Allow the bike to dry completely before using.
• Frequently vacuum the fl oor underneath the unit to prevent the accumulation of dust and dirt, which can aff ect the
smooth operation of the unit.

LUBRICATION

Remove the pedals from the crank quarterly and lubricate the threads that attach the pedals to the cranks to prevent
corrosion.
NOTE: The user's left side pedal is reverse threaded.
*Power warnings, grounding instructions, and power requirements are only applicable when this product is being used
with the optional power supply.*
NOTE: The Envision II 16" and ShowRunner II consoles require the optional power supply.
34