Panasonic KX-TGF943 Operating Instructions Manual page 50

Caller ID Service
Viewing the caller list and calling
back
Handset / Base unit
1
Proceed with the operation for your unit.
Handset: MCN CID
Base unit: MCIDN
2
Press MCN to search from the most recent
call, or MDN to search from the oldest call.
3
Proceed with the operation for your unit.
Handset:
– To call back, press M
– If you select an entry with "
" " or " " displayed, an error tone
sounds.
Wait for 2 seconds until a confirmation
message is displayed. Press MYESN if
you want to call back.
– To exit, press MOFFN.
Base unit:
– To call back, press MSP-PHONEN.
– If you select an entry with "
" " or " " displayed, an error tone
sounds.
Wait for 2 seconds until a confirmation
message is displayed. Press MYESN if
you want to call back.
– To exit, press MEXITN.
Note for handset and base unit:
R If the entry has already been viewed or
answered, " " is displayed.
R " " or " " indicates the caller
information for blocked calls.
R " " indicates the caller information for
scam calls.
Editing a caller's phone number
You can edit a phone number in the caller list
by removing its area code and/or the long
distance code "1".
Handset
1
MCN CID
2
MbN: Select the desired entry. a MMENUN
3
MbN: "Edit" a MSELECTN
For assistance, please visit http://shop.panasonic.com/support
50
TGF94x(en)_1007_ver014.pdf
4
5
1
2
3
4
N.
Caller ID number auto edit feature
" or
Once you call back an edited number, the unit
which was used to call back remembers the
area code and format of the edited number.
The next time someone calls from the same
area code, caller information is customized by
the unit as follows:
– When the call is being received, the Caller
" or
– After the call has ended, the caller's phone
For example, you can use this feature to set
the unit to ignore the area code of callers in
your area, so that you can call these local
numbers using caller information without
dialing the area code.
To activate this feature, you must edit an entry
in the caller list, then call that number. After
that, phone numbers from that caller's area
code are edited automatically.
This feature can be set for each unit (page 41,
43). The default setting is "On".
Note:
R Phone numbers from the 4 most recently
50
Press MEDITN repeatedly until the phone
number is shown in the desired format.
M N
Base unit
MCIDN
MbN: Select the desired entry.
Press MEDITN repeatedly until the phone
number is shown in the desired format.
MSP-PHONEN
Handset / Base unit
ID number is displayed in the same format
as the edited number.
number is displayed in the same format as
the edited number, when reviewed from the
caller list.
edited area codes are automatically edited.
2022/10/07 15:47:33