Cooktop Features; Burners - Jenn-Air PRO-STYLE JDRP548HL Use & Care Manual

BURNERS

WARNING
Fire Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death
or fire.
BURNER
BTU/hr
APPEARANCE
Large
stacked
burner
Small
burner
Igniting Burners:
Electric igniters automatically light the surface burners
■
when burner knobs are turned to IGNITE.
Before setting a burner knob, place filled cookware on the
■
grate. Do not operate a burner using empty cookware or
without any cookware on the grate.
Visually check that the burner has lit. If the burner does not
■
ignite, listen for the clicking sound. If you do not hear the
igniter click, turn off the burner. Check for a tripped circuit
breaker or blown fuse.
FEATURES
This burner has an upper
and lower level of flame.
The Hi setting uses both
flame levels at full power to
provide the highest heat.
It is ideal for cooking large
quantities of food or liquid
and using large pots and
pans. The Simmer Hi and
Lo settings use the lower
flame only.
This burner is ideal for
cooking smaller quantities
of food and melting
chocolate or butter.

COOKTOP FEATURES

Check that the burner knob is pressed completely down
■
on the valve shaft. If the spark igniter still does not operate,
call a trained repair specialist.
When the burner knob for the desired burner is turned to the
■
IGNITE position, the burner will click independent of the other
burners.
REMEMBER: When range is in use or during the Self-
Cleaning cycle, the entire cooktop area may become hot.
Flame-Sensing™ Reignition Feature
During cooktop use, if one or more burners are extinguished
due to external causes (such as a water spill, wind, or
ventilation draft), the ignition system will turn on to reignite
the flame. When the flame comes back on, the system will
stop sparking. If the draft in the room is not removed, occasional
sparking may continue. Sparking may also occasionally occur
when using the low setting on a burner.
To Set a Burner:
1.
Push in and turn
counterclockwise
to IGNITE.
Turn knob counterclockwise further for Simmer Hi and Simmer Lo.
In Case of Power Failure
Hold a lit match near a
burner and turn knob
counterclockwise to Hi.
After burner lights, turn
knob to desired setting.
2.
Turn knob
counterclockwise
between Hi and Lo.
13