General Information - MULTIQUIP Mikasa Series Operation And Parts Manual

Definition of Tamping Rammer
The Mikasa MTR-40F Tamping Rammer is a powerful
compacting tool capable of applying a tremendous force in
consecutive impacts to a soil surface. Its applications include
soil compacting for backfilling for gas pipelines, water pipelines
and cable installation work.
The impact force of the MTR-40F levels and uniformly compacts
voids between soil particles to increase dry density.
Circular motion is converted to create impact force. The MTR-
40F tamping rammer develops a powerful compacting force at
the foot of the rammer. To maintain optimum performance, proper
operation and service are essential.
Construction of Tamping Rammer
The Mikasa MTR-40F is equipped with a Robin air cooled, four
cycle gasoline engine. Transmission of the power takes place by
increasing the engine speed to engage the centrifugal clutch.
Rammer Spring Cylinder and Crankcase Bearings
The Mikasa MTR-40F uses zerk grease fittings to lubricate the
spring cylinder and crankcase bearings. Lubricate these grease
fittings as referenced in the maintenance section of this manual.
Controls
Before starting the MTR-40F Tamping Rammer identify and
understand the function of the controls, see Figure 1 on page 13.
PAGE 12 — MTR-40F—OPERATION AND PARTS MANUAL — REV. #1 (11/14/07)
MTR-40F — GENERAL INFORMATION
CAUTION CAUTION
CAUTION CAUTION CAUTION
Before starting operation check the lifting
handle to:
1. Make sure that there is no damage on the bolts.
2. Make sure that there is no crack or breakage on handle.
3. Make sure that there is no fissure on the surface. If there
is any abnormality or damage, replace with new one.
For operation:
This handle is to be used to lift up the shoe part of the machine
with the body laid down on the ground or truck bed.
1. Use proper lifting techniques to avoid back injury. This
handle is for manual lifting only.
2. Do not use this handle as a rammer lift point. Use the
lifting point on the top of the machine.
3. Do not move the rammer with the lifting handle and the
front rollers more than (16 feet) 5 meters.
Handle Operation