Using The Menus - Toro Reelmaster 5510 Operator's Manual

InfoCenter Icon Description (cont'd.)
Lower cutting units
Operator must sit in seat
Parking Brake Indicator—indicates
when the parking brake is On
Identifies the range as High
(Transport)
Neutral
Identifies the range as Low (Mow)
Coolant Temperature-indicates the
engine coolant temperature in either
°C or °F
Temperature (hot)
PTO is engaged
Denied or not allowed
Engine Start
Stop or shutdown
Engine
Key switch
Indicates when the cutting units are
being lowered
Indicates when the cutting units are
being raised
PIN passcode
CAN bus
InfoCenter
Bad or failed
Bulb
Output of TEC controller or control
wire in harness
Switch
InfoCenter Icon Description (cont'd.)
Symbols are often
combined to form
sentences. Some
examples are shown
below

Using the Menus

To access the InfoCenter menu system, press the
menu access button while at the main screen. This
brings you to the main menu. Refer to the following
tables for a synopsis of the options available from
the menus:
Main Menu
Menu Item
Faults
Service
Diagnostics
26
Operator must release switch
Operator should change to indicated
state
Warm-up mode
Operator should put machine in
neutral
Engine start denied
Engine shutdown
Engine coolant too hot
Sit down or set parking brake
Description
The Faults menu contains
a list of the recent machine
faults. Refer to the Service
Manual or your Authorized
Toro Distributor for more
information on the Faults
menu and the information
contained there.
The Service menu contains
information on the machine
such as hours of use, counters,
and other similar numbers.
The Diagnostics menu
displays the state of each
machine switch, sensor, and
control output. You can use
this to troubleshoot certain
issues as it will quickly tell you
which machine controls are on
and which are off.