Charging The 12 V Battery; Servicing The 12 V Battery; Replacing A 12 V Fuse-Block Fuse - Toro Reelmaster 5510 Operator's Manual

3. Apply a coat of Grafo 112X (skin-over) grease,
Toro Part No. 505-47 to the battery posts and
battery-cable clamps.
4. Slide the rubber boot over the positive
battery-cable clamp.
5. Assemble the cover over the battery, inserting
the tabs of the cover into the slots in the battery
tray.
6. Close and latch the hood; refer to
Hood (page 44).

Charging the 12 V Battery

1. Disconnect the battery; refer to
the 12 V Battery (page
2. Connect a 3 to 4 A battery charger to the battery
posts.
3. Charge the battery at a rate of 3 to 4 A for 4 to
8 hours.
4. When the battery is charged, disconnect the
charger from the electrical outlet and battery
posts.
5. Connect the battery; refer to
V Battery (page 56).

Servicing the 12 V Battery

Service Interval: Every 50 hours
Every 50 hours
Note:
Keep the terminals and the entire battery case
clean because a dirty battery will discharge slowly.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Open the hood; refer to
44).
3. Check the condition of the battery.
Note:
Replace a worn or damaged battery.
4. Disconnect the battery cables, and remove the
battery from the machine; refer to
the 12 V Battery (page
5. Clean the entire battery case with a solution of
sodium bicarbonate (baking soda) and water.
6. Rinse the case with clean water.
7. Assemble the battery to the machine and
connect the battery cables; refer to
the 12 V Battery (page
8. Close and latch the hood; refer to
Hood (page 44).
Closing the
Disconnecting
56).
Connecting the 12
44).
Opening the Hood (page
Disconnecting
56).
Connecting
56).
Closing the
Replacing a 12 V
Fuse-Block Fuse
The fuse block is under the seat.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Unlatch the seat base, tilt the seat base open,
and support it with the prop rods
3. Replace the open fuse
fuse type and amperage rating.
1. Fuse block
4. Rotate the seat and seat base closed and latch
the base (Figure
57
44).
(Figure
Figure 93
(Figure 94) with the same
Figure 94
95).
93).
g419565
g432164