(Figure 67); Figure 106 - Toro Reelmaster 5510 Operator's Manual

fluid, replace the return-hydraulic filter and
charge-hydraulic filter.
Important:
Use of any other filters may void the
warranty on some components.
Changing the Return Filter
The hydraulic system is equipped with a return
filter-service indicator (Figure
the filter-service indicator through the hole in the
floor plate. With the engine running at operating
temperature, check the color of the indicator as
follows:
•
Green indicates normal hydraulic-fluid flow through
the filter.
•
Ref indicates a restricted filter. Change the return
filter.
Figure 105
1. Hydraulic-filter-restriction indicator
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. At the front of the machine, align a drain pan
under the return filter
105). You view
44).
(Figure 106).
1. Return filter
3. Remove the filter.
4. Wipe clean the filter mounting area of the filter
head.
5. Apply a thin coat of the specified hydraulic fluid
to the gasket of the new return filter.
g004132
6. Thread the filter onto the filter head by hand until
the gasket contacts the mounting surface, then
rotate the filter an additional 1/2 turn.
Changing the Charge Filter
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Tilt the seat; refer to
3. At the left side of the machine, align a drain pan
under the charge filter
64

Figure 106

2. Filter head
44).
Tilting the Seat (page
(Figure 107).
g376340
45).