Dell EMC VEP1400 Getting Started Manual page 17

Figure 7. VEP1400 wall mount installation - keyhole cutout
To mount the VEP1400 unit to the wall using the wall mount bracket provided, you must
first anchor the screws into the wall surface. Depending on the type of wall surface, use
the M3 screw and anchor to ensure a secure installation. The recommended M3 screw
dimensions are as follows:
Figure 8. VEP1400 wall mount, installation anchor, and screw dimensions
NOTE: Before mounting the VEP1400 to the wall, verify that the wall surface is
strong enough to support a firm installation of the unit and can withstand the
weight of the unit, power cable, and network cabling.
After the brackets have been attached to the VEP1400 unit and the screws that are
mounted into the wall, place the brackets over the screws and slide the unit to one side to
secure the unit in place.
WARNING: When mounting the VEP1400 unit to the wall, ensure that unit is
mounted with the parallel ports in the upward position, and where the LED panel
faces the floor.
17