Dell EMC VEP1400 Getting Started Manual page 15

Figure 3. VEP1400 wall mount installation - cross-shaped cutout
To mount the VEP1400 unit to the wall using the wall mount bracket provided, you must
first anchor the screws into the wall surface. Depending on the type of wall surface, use
the M3 screw and anchor to ensure a secure installation. The recommended M3 screw
dimensions are as follows:
Figure 4. VEP1400 wall mount, installation anchor, and screw dimensions
NOTE: Before mounting the VEP1400 to the wall, verify that the wall surface is
strong enough to support a firm installation of the unit and can withstand the
weight of the unit, power cable, and network cabling.
Using the measurements provided in the following diagram, use the measurement in the
red box to mark the distance between the two installation points:
15