Table of Contents
Advertisement
Troubleshooting
Symptom
$ Server's power LED fails to light
even when the power switch is ON.
$ No display on the display panel
even though the power switch is
on.
$ The buzzer continues to sound
after the operation LED has lighted.
$ No control can be exercised using
RS-422A.
$ There is no sound.
$ Video recording stops at an interim
point.
Suggested remedial action
O Has the power cord been connected?
O Do the installed fuses have the rated amperage?
O Has the power been turned back on immediately after it was turned
off?
Wait at least 10 seconds after turning off the power before turning it
back on.
O Something has malfunctioned.
Check on the display panel.
O Have the cables been connected properly?
O Is the server mode set to LOCAL?
Check on the display panel.
O Are the cables connected properly?
O There is no audio output during playback at speeds lower than 1a
speed.
O Is there space on the HDD?
Check remaining time on the display panel or using Odetics/Louth
protocol.
O Is access to the HDD delayed?
O Is there anything wrong with the input signal?
O Is FC cable connected properly?
37
Advertisement
Table of Contents
