Table of Contents
Advertisement
Display Panel
$ Parameter Setting Screen
Each parameter required by the unit is set.
1. Then screen for selection of CONFIG TYPE is
shown.
CONFIG TYPE is selected with cursor button [ ! ] or
[ 1 ].
USER SET
A/S SET
If the parameter does not need to be changed,
press the [CANCEL] button.
When the [CANCEL] button is pressed, main
screen pattern 1 is restored.
2. When the [SET] button is pressed, the unit moves
to the screen for change of setting items or setting
values.
3. The setting items are changed by cursor button [ # ]
or [ 2 ] and the settings are changed by cursor
button [ ! ] or [ 1 ].
4. When setting value has been determined, press the
[SET] button.
By pressing the [SET] button, changes in
parameters are recorded in the main unit. (Screen
does not change.)
5. Similarly, other setting items are set by cursor
button [ # ] [ 2 ] or [ ! ] [ 1 ] and recorded by the [SET]
button. To select CONFIG TYPE, press the
[CANCEL] button.
6. When all the settings are completed, press the
[CANCEL] button and return to the screen for
selecting CONFIG TYPE.
2 2
1 1
7
7. Press the [CANCEL] button again.
When the USER SET parameter has been
changed, one of the following screens will be
displayed. Press the [SET] button to restart the
system.
If the USER SET parameter has not been changed,
the system will return to Main Screen Pattern 1.
<Notes>
O The USER SET parameter becomes effective
following restart after the setting has been changed
and the [SET] button has been pressed.
When the USER SET parameter has been
changed, be sure to always restart the unit.
O The A/S SET parameter becomes effective after the
setting has been changed and the [SET] button has
been pressed.
22
Advertisement
Table of Contents
