Set up, install, and configure
Using the Embedded Web Server
1
Open a web browser, and then type the printer IP address in the address field.
Notes:
•
View the printer IP address on the home screen. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
•
If you are using a proxy server, then temporarily disable it to load the web page correctly.
2
Click Settings > Fax > Fax Setup > General Fax Settings.
3
Configure the settings.
4
Apply the changes.
Setting up the fax function using etherFAX
Notes:
•
The printer firmware must be updated to the latest version. For more information, see
firmware" on page
•
An appropriate license bundle must be installed in your printer. For more information, contact etherFAX.
•
Make sure that you have registered your printer to the etherFAX portal. For more information, go to
https://www.etherfax.net/lexmark.
•
The printer serial number is required on registration. To locate the serial number, see
serial number" on page
1
Open a web browser, and then type the printer IP address in the address field.
Notes:
•
View the printer IP address on the home screen. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
•
If you are using a proxy server, then temporarily disable it to load the web page correctly.
2
Click Settings > Fax > Fax Setup > General Fax Settings.
Note: Fax Setup appears only if Fax Mode is set to Fax.
3
In the Fax Name field, type a unique name.
4
In the Fax Number field, enter the fax number that etherFAX provided.
5
From the Fax Transport menu, select etherFAX.
Notes:
•
This menu shows up only when more than one fax transport is available.
•
If the printer only has etherFAX installed, then it is automatically configured.
6
Apply the changes.
50.
10.
31
"Updating
"Finding the printer