Leaving The Range Of The Transmitter - Sennheiser RS 2000 Instruction Manual

Problem Possible cause
The balance is misadjusted.
The audio cable is not properly
Sound only on connected.
one ear
The TV has only a mono head-
phone socket.
The audio cable is defective.
The signal of the audio source is
Sound is dis-
distorted.
torted
The volume on the stethoset
receiver is adjusted too high.
Receiver
The
The rechargeable battery is
status LED
almost empty.
lights up red
The operating The rechargeable battery is
time decreases exhausted.
The stethoset receiver is not
paired with the transmitter.
The stethoset
The distance to the transmitter
receiver does
is too large.
not connect to
the transmitter
2 stethoset receivers are cur-
rently connected to the trans-
mitter.
If a problem occurs that is not listed in the above table or if the problem cannot be solved with
the proposed solutions, visit the RS 2000 product page at www.sennheiser-hearing.com.
There you will find a current list of frequently asked questions (FAQ).
You can also contact your Sonova Consumer Hearing partner for assistance. To find a Sonova
Consumer Hearing partner in your country, search at
www.sennheiser-hearing.com/service-support.
Possible solution
Adjust the balance.
Check the audio plug connection.
Use an adapter (mono to stereo
jack socket) to connect the
transmitter to the TV.
Replace the audio cable.
Reduce the volume of the audio
source.
Reduce the volume on the ste-
thoset receiver.
Recharge the rechargeable bat-
tery.
Have the rechargeable battery
replaced by an authorized Sonova
Consumer Hearing partner.
Pair the stethoset receiver with the
transmitter.
Reduce the distance between the
stethoset receiver and the trans-
mitter.
Up to 2 stethoset receivers can be
simultaneously used with the
transmitter.

Leaving the range of the transmitter

The range of the transmitter largely depends on environmental
conditions such as wall thickness, wall composition etc. If you,
and therefore the stethoset receiver, leave the range of the
transmitter, the audio drops out occasionally at first before the
connection breaks down completely. The
on the stethoset receiver flashes green (or red if the recharge-
able battery is almost empty). The transmitter automatically
switches off (standby) when there is no stethoset receiver
Transmitter status
connected. The
If a problem occurs ...
Receiver status
LED goes off.
RS 2000
Page
17
9
–
–
–
16
13
19
20
–
–
LED
| 23