Switching The Wireless Headphone System On - Sennheiser RS 2000 Instruction Manual

Using the RS 2000
Vol +
Vol -
14 | RS 2000
Using the RS 2000

Switching the wireless headphone system on

WARNING
Danger due to high volume levels!
This receiver allows you to set higher volumes than conven-
tional devices. Constant high-volume use can cause hearing
damage.
b
Before putting the stethoset receiver on, set the volume on
the receiver to a low level.
b
Do not expose yourself to high volume levels for extended
periods of time.
1 Switch your audio source on.
If the transmitter is connected to the headphone socket
(see page 10) of your TV/audio source, adjust the volume of
VOLUME
the headphone socket on your TV/audio source to at least
a medium level.
2 Take the stethoset receiver out of the transmitter's
charging compartment and pull the ear bows apart so that
you can put the receiver on.
The stethoset receiver automatically switches on when you
pull the ear bows apart. The
green. The transmitter automatically switches on and the
Transmitter status
sion starts.
1
ON
Receiver status
LED lights up green. The audio transmis-
2
ON
LED lights up