Table of Contents
Advertisement
Charging the stethoset receiver's rechargeable
battery
A complete charging cycle takes about 3 hours. Before using
the receiver for the first time, charge its rechargeable battery
for a complete charging cycle without interruption.
When the rechargeable battery is almost empty, the
status
LED lights up red. The stethoset receiver switches off
after a few minutes.
b
Place the stethoset receiver into the transmitter's charging
compartment so that the volume buttons face upwards. The
stethoset receiver is magnetically oriented to the correct
position. The stethoset receiver automatically switches off
Charge status
and the
red. When the rechargeable battery is fully charged, the
Charge status
LED
Always store the stethoset receiver in the transmitter's
charging compartment to ensure that it is fully charged
when needed. The intelligent battery charging technol-
ogy prevents overcharging.
If the transmitter's
charging error/battery error has occurred. In this case,
remove the stethoset receiver from the transmitter's charging
compartment. More information on the rechargeable battery
can be found on page 19.
Putting the RS 2000 into operation
LED
on the transmitter lights up
goes off.
Off
Charge status
LED
Receiver
3 h
100
%
flashes red, a
RS 2000
| 13
Advertisement
Table of Contents
