Table of Contents
Advertisement
Using additional functions
20 |
RS 2000
Using additional functions
The following additional functions are not required for normal
use of the wireless headphone system. You can, however,
extend the potential use of the system.
Pairing the stethoset receiver with the
transmitter
The stethoset receiver and the transmitter of your wireless
headphone system are factory pre-paired. The following steps
are only necessary if you want to reestablish the pairing or pair
additional stethoset receivers with the transmitter.
You can simultaneously connect up to 2 paired stethoset
receivers with your transmitter.
1
Make sure that there is only 1 transmitter within transmis-
sion range with which you want to pair the stethoset
receiver.
2
Place the stethoset receiver as close as possible to the
transmitter.
3
Switch the stethoset receiver on by pulling the ear bows
apart.
4
Simultaneously press and hold the volume buttons
at least 5 seconds until the
green rapidly.
5
Then release the volume buttons +/–.
Once pairing is completed, the
Transmitter status
sion starts.
1
3
ON
Receiver status
Receiver status
LED light up green. The audio transmis-
2
4
+/–
for
LED flashes
LED and the
5
Advertisement
Table of Contents
