Substitute Memory Reception; Print Collation Mode - Panasonic Panafax UF-885 User Manual

Substitute Memory Reception

If the recording paper runs out or jams or if the toner runs out during reception, the machine automatically starts
receiving documents into its image data memory. Stored documents are printed automatically after replacing the
recording paper or the toner cartridge. (See Note 1 and 2)
1
When the machine finishes the memory reception and
there is no recording paper or toner, an Information Code
appears on the display.
2
Install the recording paper (See page 18) or replace the
toner cartridge (See page 16).
The machine will automatically start printing the
document stored in the memory.

Print Collation Mode

The printing mechanism of the UF-885/895 is a Reverse Order Stacking construction. The UF-885/895 has a
Print Collation Mode that stacks received documents in the correct order. When the Print Collation Mode is
enabled, all received documents are stored into memory first, then printed out in Correct Order Stacking. The
requirements for the Print Collation Mode to be active are; 1) Fax Parameter No. 65 PRINT COLLATION set to
"Valid", and 2) enough remaining memory.
The unit will print in Reverse Order Stacking (Non-Collation Mode) whenever one of the above requirements is
not met.
To use this function, we recommend installing an Optional Flash Memory Card. See page 173 (Options and
Supplies).
Sending Document Order
1
2
3
Note:
1. If the memory overflows, the machine will stop receiving and release the communication line.
The document(s) stored in the memory up to that moment will be printed out.
2. If you wish to turn off the substitute reception function, change the setting of Fax Parameter No. 22 to "Invalid". (See
page 35)
Receiving Documents
(see Note 1) (see Note 2)
Stacking Document Order
Correct Order Stacking
(Collation Mode)
1
2
3
NO RECORDING PAPER
INFO. CODE=010
OUT OF TONER
INFO. CODE=041
* PRINTING *
MEMORY RCV'D DOC
Reverse Order Stacking
(Non-Collation Mode)
3
2
1
4
63